itt Pico S Repair Tips
Search: Pico S itt
Results 19
Results 19
Make | Model Ch. | Symptom | Problem Solution | Solution | By: |
---|---|---|---|---|---|
ITT | Pico S3 | Dead apart from brief led flicker at sw on | LOPTx | ||
ITT | Pico S3 | Dead - life restored if scan coils dis'd | Width control coil on scan coils has shorted turns | ||
ITT | Pico S2 | Dead - no relay click or display | Mains st/by tfmr o/c pri | ||
ITT | Pico S2 | Dead - no relay click at switch on. | Standby mains transformer primary winding o/c. | ||
ITT | Pico S | St/by only | relay clicks at sw on but no HT to LOP Tr; C701 10µ 350v faulty | ||
ITT | Pico S | Pulling/bouncing/int loss of sound | C212 10µ 50v in CMR800 (top of can) | ||
ITT | Pico S | No sound | R1075 3R3 safety res o/c; C229 220µ s/c | ||
ITT | Pico S | Misty pic - poor col with red flaring | Earthing ring on crt base shorting to cathodes | ||
ITT | Pico S | Int dead when heated | 115v HT still present; dry joints LOP tr | ||
ITT | Pico S | Display shows "88" | SAA1292 chip faulty - caused by dry joints esp on C10 1000µ | ||
ITT | Pico S | Dead. | Check small LT transformer for o/c. | ||
ITT | Pico S | dead | 2A fuse on front panel o/c; degauss therm caused it | ||
ITT | Pico S | Blank raster with line tearing - sound int | C524 10µ | ||
ITT | Pico S | Bad hum bar & no sound | Replace 4 x 1N4007 mains rects | ||
ITT | CT3325 Pico S | No colour after few hours. | T1410 in tuner control unit ( IFB351 ) | ||
ITT | CT3315 Pico S | Dark picture. | 270k resistor in 1st anode supply. | ||
ITT | CP3106 Pico S | Frame - reduced. | If IC401 pin 9 down to 19v suspect LOPTX. | ||
ITT | PICO S3 | STBY LED FLICKERS BUT DEAD . PIN 4 LOPTX REMOVED P | LOPTX US | ||
ITT | PICO S3 | DEAD IF SCAN COILS DISCONNECTED TRIES TO RUN | WIDTH CCT ON SCAN COILS SC |